Rust Tough RTA9207 Rust Preventative Spray Enamel 12 Oz, Almond

Rust Tough® Rust Preventative Enamel

Rust Tough® sprays directly onto metal surfaces to stop and prevent rust.

• Color: Almond
• Size: 12 Ounce
• No primer needed spray directly on metal surfaces.
• Stops future rust from forming and dries in less than 30 minutes.
• Low odor, one-coat coverage.
• Easy soap and water cleanup.

Dry to Touch: 30 minutes

Dry to Handle: 2 hours

For use with: Wood, Metal.

Surface Preparation:-

For surface preparation of specific surfaces, refer to the guidelines below.

The most important step to surface preparation is to be sure that the surface is clean, dull and dry. Ordinary household detergent or mineral spirits usually do the job.

There should not be any flakes of paint or rust on your surface before priming or painting. Be sure to remove any loose paint or rust with a wire brush, sandpaper or steel wool.

Your surface should also appear dull or matte. Lightly sand glossy surfaces with fine grain sandpaper and wipe clean with a tack cloth.

When working with wood

• Staining Wood: Lightly sand bare wood smooth with medium to fine grain sandpaper.  Wipe clean with a damp rag to remove dust.  If previously painted, remove the paint to bare wood.  If previously stained, make sure the stain will penetrate before using. Splash a couple drops of water on the surface. If the water penetrates, then so will the stain. If not, you may have to sand the surface first. Surface should be clean, dull and dry before staining.
• Painting Wood: Sand bare wood smooth with medium to fine grain sandpaper. Wipe clean with a tack cloth to remove dust. Spray with primer to seal the surface if desired. Lightly sand glossy surface if previously painted and remove dust with a tack cloth. Outdoor wood should always be primed before painting for greatest durability.

When working with metal

Remove loose rust with a wire brush, sandpaper or chemical rust remover. Remove oil with a degreaser or denatured alcohol especially on new metal. Prime surface to protect against rust and corrosion. Lightly sand glossy surface if previously painted and remove dust with a tack cloth. Outdoor metal should always be primed before painting for greatest durability.

When working with plastic

For old plastic, use an ammonia-based cleaner and wipe down to clean surface. If the plastic is new, wipe down with paint thinner for best results. Lightly sand glossy surface if previously painted and remove dust with a tack cloth. When dry, apply Krylon® Fusion for Plastic according to the directions on the can.

 When working with wicker

Wicker should be clean, dull and dry prior to painting. Lightly sand glossy surface if previously painted and remove dust or prime. Outdoor wicker should always be primed before painting for greatest durability.

When working with glass or ceramic

Lightly sand with fine grain sandpaper so that surface will not be slick – this allows paint to adhere better. Wipe clean with a tack cloth. Apply a primer to further improve adhesion (glass will no longer be transparent if a primer is used).